Celica DIY original LED ring teil

Mission Make the original LED tail And put on ring type
	Most Japanese web-site said that When remove the tail lens, into the hot water I put into hot water and challenge removing But the result is that it was cracks I think it is impossible to remove the lens So I done another way Б@
expanded if it clicks	I judged that it is impossible to remove lens So I punctured the other side with the cutter Cutting point is bottom side because of rain measures
	This time, I use 1mm polystyrene board for putting LED It is easy to cut with scissors Make the hole to put FluxLED by hammer and needle FluxLED have heat when it is lighting So It doesn't completely join it to polystyrene board
	Put FluxLED on the bord Please check LED's anode and cathode( plus and minus) I use Red FluxLED (2.2V), so it is single-unit by 4 pieces Use 4 LED unit, total 16 FluxLEDs Wiring It have to change quantities of light when brake and illumination So I used resistance with different value THis Resistance value is different by LED maker and your favor
	Put into the tail It shines clearly when LED is brought close to the lens side And dimly when LED is separated I want clearly shine, so bring close to the lens Fixed them with the clear adhesive When this time, don't touch adhesive to tail lens
	This is my work desk very very dirty hahahaha put 2 LED circuits into tail and fixed After that, I waterproofed it with the vinyl tape 2nd photo is illumination, and 3rd photo is brake Б@
	after the attaching CELICA's photo Left side is original LED tail and right is nomal And 1st photo is illumination 2nd is brake I am very satisfaction it is very good lighting
	My dirty desk again I made right side tail as much as left It was 2 times, so it is easy to make it You can see the ring FluxLED when not lighting It is very good spectacle
Б@Б@ Nice job myself !! It seems like SKYLINE or RX7(FD3S) !!