Facebook Twitter RSS Feed

Floating Trunk






NOTE:
Refer to above picture for steps 1-3.

1)
This part must be cut out. You must measure
1/2 of the thickness of the bar, and cut exactly that
much above the hole you are about to drill to make
it sit flat (not leaning back).


2)
Remove this screw. Drill a new hole here, right
through the stock hole. This will be the pin that
trunk rotates on. The stock hole is slotted. Make
sure the pin fits loosely, which will allow it more
play so it will sit sideways.

3)
Drill a NEW hole here (not through the other
stock hole). This will be the pin you remove.
You can replace this pin, to lock it back into
stock operation. Make sure this hole is drilled
near exact diameter of your pin or your trunk
will sit up too high.

4)
Remove the stock screw. You will have to
grind the inside a bit, to allow it to clear the
bar, unless you cut you hole to big. Don't
grind too much, so you can still replace the
stock screw if you want to get rid of the flip flop.

NOTE:
If you have a wing, tighten the springs
to make it stay up. I had to shorten mine.
.
The trunk will now sit sideways OR sit like a
normal flip flop.

Pics of the finished product:



0 komentāri:

Post a Comment