Lighting CELICA emblem

Mission Light the rear celica emblem and When the brake, change blue to red
expanded if it clicks	My 6gen CELICA have rear "CELICA emblem" Don't you think it is funny if it light? So I use chip LED and light backside This CELICA emblem is put up with the adhesive tape So remove it carefully by like Fishing string How to light LED circuit is placed by Emblem and Plastic board to have shape of emblem Use chip LED's height is 2mm, too small
	Make the CELICA plastic board it thickness is just 2mm
	This is the LED circuit layer And there are many blue LED chip are on there It is very small (2mm) , can you see it ? Wiring line is copper tape You can see 3 line on the circuit 1 Brake : red chip LED 2 Illumination : blue chip LED 3 GND(earth)
	Check lighting This blue chip LED is 3.3V And after, wire both side circuit It is very detailed work So I want not to make again
	attach LED circuit and plastic board So I unctures it where on chip LED And make 3 wire line [brake] [illumination] [GND]
	Brake lights Red chip LED Illumination lights Blue chip LED Blue LED is 3.3V and Red LED is 2.0V But it is different Voltage by maker Б@
	At last Docking Using clear adhesive
if click this photo, the move start	Changing color is used coil type switching circuit Brake : red illumination : blue Brake when illuminate : red 3rd photo, if you click this photo, the move start Ummmm Red shines thinly
	Trunk lid doesn't have illumination line So have to draw this line from back lamp through into the trunk lining Brake line get trunk lid brake lamp This is poto of after remove emblem Make a hole to pass wiring by Electric drill After that, 3 lines wiring [brake] [illumination] [GND]
	Confirming the operation Illumination and braking Blue is very very good but red shines thinly At the photo, can't see red hahahaha